hi, and thanks everyone. recently completed the delta H2 printer from seemecnc, it has the HE280 hot end unit on it? the 8-pin wiring harness is very finicky on it, and i need to fidget it a bit to get the printer either pre-heating when i want and/or heating to 220 when i goto print, i need to fidget a bit,,, thus can i get your locking 8-pin connector and use in my printer? i dont really see where it 'locks or clicks' into the he280? currently there is just the 8-pin (black no side clips) that goes in, and needs fidgeting... what does the locking version lock to, (under the plastic cover of the he280)?
also, im a also upgrading the basic glass bed to an orion heated bed i ordered, it came with a thermistor, a capacitor, the red and black power wirtes and some addtl wires.
however, if possible, if anyone has done this, can you send me a pic of exactly what to solder and where on this orion board.. thanks! also, i understand i need to add another power supply, i read to order the xbox360 power supply, clip the end, and put those into the mini-rambo for the power in for the heated bed...?
Also you want to make sure the simply don't have a loose connection in the one you have. These clip into the small square hole on each side of the matting plug on the HE280.
I'm not sure about your heat bed question,
Some things are meant to be closed. Your mind isn't one of them.