3d noob!

[thundy71]

Hiya! My name is Tim Paszli, I worked with Glenn at Royale coach. Paul Gross recommend getting in touch.

I got my first 3d printer for Christmas. It's an Anet A8. I'm computer savvy, but this is just new to me. There's instructions with the printer, but very vague and out of date. I'm having problems with software, specifically Cura. The instructions for the printer skip right through setup, with pictures of menus no longer in Cura. There's no info on much of anything as far as software goes.

I'm pretty sure I've built it properly, but I'm looking for help. I've kind of ground to a halt over software. Is there anyone who would be able to give me a few pointers?

Thanks,

Tim Paszli

[BeeAmaker]

Hay Tim, hows it going? This Glenn.

We have meetings every Thursday night. starting at 6pm and usually run until midnight. Stop in any Thursday with your printer and we will see what we can do for you. Since you are not a regular member, all we ask is a small donation to our group for the knowledge and beer.

[thundy71]

I'm excited to absorb some knowledge. I'll see about this Thursday. Just a heads up, I've developed a few issues. Stairs are challenging for me, and I think I saw you are on the second floor. I may need assistance getting my gear upstairs.

[thundy71]

Would you like that donation in cash or food and drink?

[BeeAmaker]

If stairs are a problem, we can take a look at it down in the shop if you want. I'm sure we can get your gear up stairs easy enough also, up to you

cash is good, we have plenty of food and drink, thanks
]