Post by jimustanguitar on May 31, 2015 11:44:06 GMT -5
I backed their kickstarter when it ran. They've got it figured out for PLA, but they found that ABS temps make their material degrade, and they haven't figured out a solution for it yet.
They shipped the PLA plates, but I and several others elected to wait until they figured out an ABS solution.
Post by jimustanguitar on Jun 1, 2015 15:16:31 GMT -5
It's some sort of spray on coating. In one of their update pictures you could see that it was on too thick and had orangepeeled.
Their first backer update was hilarious. They showed their laboratory in somebody's mom's basement and their manufacturing facility on a table between somebody's bumper and the wall in a garage...
Since then they've rented space at an incubator somewhere and have been getting mentorship and things like that. Hopefully they can still figure out what they need to, to do ABS temps before they go upside down trying.
