I checked on a print and saw that it wasn't extruding, so I looked at the temperature - 26°! I started tracing the wires and found that one of the wires going into the cartridge on my hot end had broken right where it goes in. I'm thinking that it's not going to be possible to fix this, but thought I'd throw the question out there in case any of you have managed a repair like this.
If it's not repairable, what would be a good source for a cartridge? I know that the dimensions are 4.93mm diameter with a length of 25.00mm. Is there anything else I need to know to find a different one?
Hardware eventually fails. Software eventually works.
That's what I was afraid of - my hotend (Ubis) uses a 5mm cartridge. May have to bite the bullet and get it from Printrbot. I could use some other parts too...
Hardware eventually fails. Software eventually works.